2012 small fan

1.Air Turbo technology 2.No blades 3.Touch tilt 4.Beautiful and fashion

Product features:

Using a unique and effective water evaporation cooling technology, only need to add water to activate the cooling function, only uses 4 AA batteries, can easily enjoy this little guy blowing moist air, used in the 4 general AA battery, can be used for more than 5 hours. So don't worry about midway strike.

Product parameters:

1: there are two kinds of working mode of air conditioner

Refrigeration and the ordinary fan model

Respectively: random with a wet sponge (to do not drop as the standard ) in the back of the machine sponge zone. Turn on the air conditioner, can realize cold air refrigerating

If you do not require refrigeration, the sponge is taken out, continue to open air, there would be no wind blowing

Products with a wooden paddle absorbent sponge can be repeated use of!

2: power supply mode

Air supply way three

1, 4 section of battery 5 ( to be self-made )

In 2, USB interface power supply ( random with USB line )

In 3, supply power directly ( AC adapter required user-owned )

In 3, the matters needing attention

A: products are not waterproof products, sponge and water should be removed after adding water to. No direct injection, to prevent water from entering the machine internal damage

B: sponge humidity to fill water is not accurate. As the water too much can wring dry add unit

C: products of high fall, when use please note

D : recommendations for each use. Please dry sponge sponge, to prevent the breeding of bacteria and odors.

Battery installation

Battery compartment located on the handle, in the next hand

1) sliding downward and remove the battery compartment cover

2) with 4 new AA alkaline batteries

3) to cover the battery compartment lid

4) long-term use please remove the battery

Can the external power supply, external power supply device in belt on the DC socket interface

1) we will configure alternative power device DC plug socket

2) the household power supply can be in no battery state using portable cold

The installation of water sponge

1) to switch the machine off

2) by pushing the top lever is pulled outward, the sponge sponge to take cover with water cooling

3) was used for the first time: the water sponge in water immersion and thoroughly with soap knead. Please be careful with sponge, don't wash it too hard.

4) if the sea had last used left the water, please put the sponge from the lid removed, the remaining water out.

5) please in the water in sponge sponge flat lid at the same time according to the following description : on the bottle is filled with water, distilled water or mineral water, then the 30ML evenly and slowly pour water in the sponge surface everywhere.

6) the first insert point jack, along with a sponge sponge cover on a fresh install, and then put the cap into the host so as to lock.

Note: do not excessive soaking water sponge. Stop flowing water below the brewing sponge. Master soaked with 30ML water is difficult, please always use water in the bottles.

2012 small fan